SAFETY PRECAUTIONS:

CAUTION: Risk of Electric shock. Do not open.
CAUTION:To reduce the risk of electrical shock. Do not open covers.
No user serviceable parts inside. Refer servicing to qualified service personnel.

GRAPHIC SYMBOLS EXPLANATION:

The lighting flash with a arrowhead symbol, in an equilateral triangle, is intended to alert the user. There is uninsulated"dangerous voltage" presence near the product's enclosure which may be a risk to people.

The exclamation point within an equilateral triangle is to alert the user to reference of the important operating and maintenance (servicing) instructions.



1.0 Features:
Compact and attractive appearance, Indoor/Outdoor design.
Motor running stable.
Flame-retarded ABS material.
Adjustable horizontal limit switcher, the unit capable of operation with load to 6 Kg.
RS485 data communication.
With internal decoder, Multi-protocol,baud rate for selectable.
Pan speed:5/sec; Tilt speed:5/sec.
With line scanning function.


2.0 Description of the Dip-switcher setting:

2.1 Dip-switcher,
6-Dip switcher:1-4 for Protocol, 5-6 for Baud rate; 10 Dip switcher (frontal 9-DIP) is for the address setup: 511, count it as the binary system.

2. The setting of the protocol and the default baud rate:

3. The setting of the baud rate:

4. Address Setting:
Before the application of the Dome pan and tilt, the address codes should be set first by DIP1 to DIP9 of SW1 on PCB in binary 8421 coding system, in which DIP1 means lower bit and the maximum address is 511. State ON of the dip-switch means "1" while OFF means "0". Some address codes of the dip-switch are set as above.

2.5 Selection of 120 Terminal Resistor:
The DIP-10 of SW1 is used to select 120 terminal resistor. In order to remove the reflection of echo wave in communication circuit, you can connect a 120 terminal resistor in parallel between 485+ and 485- of the Dome (set the selection bit of 120 terminal resistor at ON). The standard of RS485 industrial bus requires all equipment should be connected in daisy-chain style and both ends should be connected with 120 terminal resistor (see Figure 5). The simplified connection can be done as Figure 6 but distance "D" couldn't be larger than 7 meters.

3.0 Dimensions:

4.0 The facility system connection:

5.0 Description of the line out:
Red line (AC 24 V in)
Black Line (AC 24 V in)
Orange line (RS485+)
Yellow line (RS485-)

Red connector block (power in)
Black connector block (RS485 control in)

Video Out
Red: DC 12 V
Black:GROUND
Orange: ZOOM
Blue: FOCUS
Pink: IRIS
White: COMMON
White:VIDEO+
Black:VIDEO-
Lens Control